Shine Supply
Shine Supply Beadlock Pro Marine - 50 ml
Shine Supply Beadlock Pro Marine - 50 ml
Couldn't load pickup availability
Shine Supply Beadlock Pro Marine is an easy to apply ceramic coating that is designed to increase gloss and protect your gel coat surfaces for a long time! Beadlock Pro Marine contains SiO2 (silica dioxide) which is the primary component of glass and is what gives glass its strength and hardness. This technology is integrated into this formula at a lower concentration than glass and is what makes ceramic coatings far more durable than traditional wax or sealants. Beadlock Pro Marine is 2.5x more concentrated than Beadlock Pro and has a solvency customized for the marine climate (hot and humid). The higher concentration provides for a single coat application whereas lower concentrated coatings such as Beadlock Pro, require several layers due to the porous aspect of gel coat. The application is easy and once it cures, cross-linked patterns create a hardness of up to 9H on the pencil scale. The surface of your boat will be smoother, stay cleaner longer, and have hydrophobic capabilities that allow for 110 degrees of contact angle to promote water beading. On top of all of that, this coating lasts up to 2 years according to the manufacturer with proper care. If you are looking to protect your paint with Shine Supply, reach for a bottle of the Shine Supply Beadlock Pro Marine!
Tips:
- 50ml bottle covers Malibu LSV 23 or similar size boat
- Can be applied to trailers, motor homes, wave runners, stainless steel, plastic trim, glass, and more!
- If you apply more than 1 coat, wait 1 hour between applications
- Coating fully cures after 48 hours. Avoid water contact for this timeframe
Directions
Optional step if needed: Polish the surface to reduce any surface defects and create maximum gloss. Wipe down the surface with Throw Back paint cleanser to remove any oils/residue left from your polishing step.
Apply: Shake well. MAKE SURE SURFACE IS CLEAN AND DRY. Apply directly onto the applicator pad and spread product evenly onto the surface. Product will have an "oil slick/rainbow" look to it as it begins to dry. This effect should begin within seconds. Give it 45 - 60 seconds to set up and then remove using a clean microfiber towel. The coating will have some slight resistance when you wipe. This slight resistance lets you know it's ready for removal. If you have difficultly removing the product, you waited too long. Using an additional towel, lightly wipe over the area again to ensure product is even and level on the surface. Once you have wiped with the second towel the coating will begin to "set-up". Do not go back into an area minutes later and re-wipe or you could cause streaking.
Pro Tips:
Use Shine Supply AFTERMATH water spot remover after each outing and Shine Supply WAKE-UP ceramic cleaner wax to maintain the layer of Beadlock Pro Marine Ceramic Coating. WAKE-UP will remove stubborn water spots AFTERMATH is unable to remove along with building the surface with additional ceramic protection.
Share
